ultimate chip & scratch protection

Unless you have a experienced eye and proper lighting you will not notice the difference between a area that's has PPF applied and one that does not. With that said paint protection film is developed for protection and not perfection so at times there will be small discrepancies within the film, but rest assured this is completely normal with the current technology of films today. 

Yes! Paint Protection Film requires water for application, so there will be small bubbles and air pockets right after application. This is completely normal and the areas will naturally evaporate and cure after 7 to 12 days of drive time in the sun. 

Modern day vehicle design is very complicated so our technicians require a lot of time for a proper application. Further more because film is applied with water, edges must naturally dry out for the adhesive to properly lay down and bond. We ask customers to be patient during the PPF process, it's not something you want to be rushed. Further more brand new vehicles or models that have been preordered sometimes require custom cut outlines for application, this also adds to instillation time.  

A "Pre Cut" is in reference to PPF instillation that has been printed by a machine such as a plotter, these prints are cut to vehicle specification for clean and accurate results. 

A "Custom or Bulk Cut" is in reference to PPF instillation that is hand outlined and cut by a trained technician. These cuts are made when needed on brand new or rare vehicle models that are not found in our systems. Custom cuts at times can be beneficial for areas such as side mirrors, hoods... because it allows the installer to achieve better coverage. 

Yes! Both our coating lines have been developed and tested for clear coat and paint protection films. We actually recommend applying a ceramic coating to your PPF because it enhances gloss, adds an anti static ability, and extends the life of your paint protection film.